TallCanadian
New member
So, I have a motor that overheats. Replaced impeller kit and thermostats. Still overheats. I decided to remove heads, covers, etc to check for blockages. How I decided to do this is to remove the power head. All went well until the last of six long motor bolts broke. It’s been a couple of days now and the power head has separated a little bit. I know that broken bolt is hanging me up. Any ideas or thoughts on how I can get this power head up. I’m at my wits end. I’ve tried lifting it from the back of the motor so to take the strain off the front bolts.
Thoughts?
Thoughts?