Logo

Gen 2 remote lower unit oil reservoir hose replacement between bell housing and thru bulkhead. HELP!

sledman1

New member
Got a hole in the hose that goes between the thru bulkhead and the bell housing that carries the lower unit oil from the remote reservoir. It is a 10 inch long hose. Looking for some help with replacing the hose. I have the outdrive off and managed to disconnect the hose from the bulkhead side but I have no idea on how to get to the other end disconnected from the bell housing. It is recessed pretty deep on the back side of the bell housing. There is the anti-dribble valve on the front side of the bell housing. Any hints or suggests would be greatly appreciated. I have the manual but what they suggest is not working.

Thanks,
Don
 
Back
Top