Hey there, so i just bout a 1983 thunderbolt with a chrysler charger 100 model 1008HOA. I haver owned an outboard, dont really know to much about them so hence my question.
A little background... when i bought the boat, it did seem like a reletivly easy project, motor was hung on the stern, turned the flywheel and figured ok, its not frozen. However, none of the wiring was connecred to the motor, none from remote control, none fom speedo, nothing to aux switches. Nothing, just a motor hung to stern. I know this motor was not origional equipment, but im hoping to get it wired to the motor. I have a couple obvious wires connected, not too sure about some others. Black to ground, red to batter + sarter to start. I cannot find ANY litrature online for this motor or even the boat for that matter. Can anyone help me with this wiring issue. After i make sure the motor runs, then ofcourse i will assemble the throttle linkages, steering rod, ect.
A little background... when i bought the boat, it did seem like a reletivly easy project, motor was hung on the stern, turned the flywheel and figured ok, its not frozen. However, none of the wiring was connecred to the motor, none from remote control, none fom speedo, nothing to aux switches. Nothing, just a motor hung to stern. I know this motor was not origional equipment, but im hoping to get it wired to the motor. I have a couple obvious wires connected, not too sure about some others. Black to ground, red to batter + sarter to start. I cannot find ANY litrature online for this motor or even the boat for that matter. Can anyone help me with this wiring issue. After i make sure the motor runs, then ofcourse i will assemble the throttle linkages, steering rod, ect.