Logo
FULL SITE MENU

Ignition problem

J

jlipe

New member
1988 Cruisers Inc. Model 2660 Vsport with Merc twin 260 HP stern drive
I have no power to Stbd ignition. Is there a fuse besides the circuit breaker at the engine? I do have power there, and at the large pig-tail on the engine. The main power wire to the ignition switch is dead.

Thank you
 
Battery connections at battery and engine.
power starts at the main post of the starter. If there is a square plastic block check the stud for 12v ,you can also check for 12v at the output term on the alt. From there power goes thru the 50 amp CB, test both sides for 12v. Then thru the engine harness plug to the dash. Check the Red wire at the ign switch for 12v then with the key on check for 12v at the purple wire
 
Back
Top