Logo

TRim has a sticking spot

ronco215

New member
My trim motor sticks as it raises about maybe 5 inches from straight down. I lower it and raise it again and it goes through the sticking spot and goes up but not all the way. It also shakes as it goes up. Down is smooth. I put oil in the cylinder and air bled it. I Greased the motor fittings. I have a 1994 Mercury 115. The # on the oil cylinder is N 1867751. I have a 3 wire 12V system.:confused: Any DIY ideas or diagnosis?
 
Last edited:
Back
Top