Have some issues with the motor going into guardian mode. Had the dealer do a scan and said manafolds were getting warm. 130 total hours on motor. salt water use. Do you need to reset it or does it reset automatically?
Suggested to do the waterpump first and then maybe manafolds. I changed the thermostasts first. No change. Then changed the impeller and the pump housing. No Change. I think I'm going to change the temp sensors next. Question is, what is inside the manafolds that can go wrong? Are there water passages in there that can corrode and cause issues. should I consider doing the manafolds?. Motor runs at about 170 degrees before alarm Goes off. I only have couple weeks left to get this done this season and would like to figure it out before winterizing. Once you let it cool for a minute at idle you will get full throttle back.
This is a closed cooling system.
Suggested to do the waterpump first and then maybe manafolds. I changed the thermostasts first. No change. Then changed the impeller and the pump housing. No Change. I think I'm going to change the temp sensors next. Question is, what is inside the manafolds that can go wrong? Are there water passages in there that can corrode and cause issues. should I consider doing the manafolds?. Motor runs at about 170 degrees before alarm Goes off. I only have couple weeks left to get this done this season and would like to figure it out before winterizing. Once you let it cool for a minute at idle you will get full throttle back.
This is a closed cooling system.
Last edited: