2004 350 Mag
I removed the fuel/water separator to gain access to the water pump drain holes and this loose cable seemed to popped out. It goes from the HP fuel pump/separator area over the forward top portion of the engine (intake) to the panel located just behind drive storage bottle/lube monitor. I believe its a red wire, and it's a dual connector but only one male connector inserted. Should this cable be connected somewhere? Alarm? Boat is winterized. I did a little research on the mercury parts breakdown page and found a "84-812733A2 harness assembly extension (Lube Bottle)"
(picture should be rotated 90 degrees clockwise)
I removed the fuel/water separator to gain access to the water pump drain holes and this loose cable seemed to popped out. It goes from the HP fuel pump/separator area over the forward top portion of the engine (intake) to the panel located just behind drive storage bottle/lube monitor. I believe its a red wire, and it's a dual connector but only one male connector inserted. Should this cable be connected somewhere? Alarm? Boat is winterized. I did a little research on the mercury parts breakdown page and found a "84-812733A2 harness assembly extension (Lube Bottle)"
(picture should be rotated 90 degrees clockwise)
Attachments
Last edited: