Logo
FULL SITE MENU

Outdrive seals

K

kangaroo_bob

New member
Hello from Brisbane (downunder).

One of my two AQ 100B outdrive legs is leaking oil. I presume it is the seal located just to the rear of the propeller. I plan to change these on both legs. Would any knowing, kind soul know the part number for these and whereabouts I might obtain two? We will be in Seattle from 26 to 28 September, so that would be a convenient place, otherwise I can have them mailed to a friend in Wisconsin.

Thanks. Bob
 
They will be "industry standard" seals and will be Metric.
Once out, you should be able to see the identifying numbers.... perhaps a P/N and the Metric dimensions.

Example:
This seal fits a 20mm shaft, a 28mm bore and is 4mm in thickness.
https://i.ebayimg.com/thumbs/images/g/uJIAAOSwjHdZYPR5/s-l225.jpg


A good bearing supplier will be able to bring them in...... or, you go directly to the supplier who would have them!


The AFT-most seal (i.e., the water side seal) must be fully encapsulated (I.E., no exposed metal)



.
 
Back
Top