The steering was so tite you could hardly turn the wheel. The steering arm bolt was froze to the arm, got that cut off and got the arm loose on spline. (engine is out) now the yoke aint moving, won't turn, and sure not dropping out.
I guess I'm just asking for some suggestion on what to try and what NOT TO DO ! I'll put heat but not sure where to. and not to.
.
1968 Chris Craft Lancer
AQ271 1987 and I think a 290 drive with trim sending unit that goes down thru the steering yoke.
I guess I'm just asking for some suggestion on what to try and what NOT TO DO ! I'll put heat but not sure where to. and not to.
.
1968 Chris Craft Lancer
AQ271 1987 and I think a 290 drive with trim sending unit that goes down thru the steering yoke.