Help with 35 HP Force model number/year

Greetings all,

Hoping someone can help ID a 35 hp Force I bought recently. The ID sticker is missing. From searching through older threads, I've seen this is a common occurrence. The motor runs great on muffs, but I think I need to at least change the impeller before I put it in the water. I need to get a repair manual, but looks like I need a model number and year of mfg to get the right one.

1) The lower cowl is aluminium and has "MADE IN USA" followed by a circle with the numbe 90 in the center.

2) The carb is made in Ireland by Tillotson. There are some identifying letters and numbers on the carb's mounting base. 717061-1 is stamped on one ear. On the other ear is stamped WB-106B-036

3) The transom bracket has some ID markings. The top number is 2014, ALCOA directly below, 684532 is the third line, with 83-2 on the bottom

4) On the starboard side of the engine, in front of the fuel pump & filter, the number RW504222 followed by a circle with the number 90 in the center.

5) The flywheel is marked PRESTOLITE ELECTRICAL DIVISION

6) The control panel is marked US MARINE

Thanks for any assistance

The circle with the 90 in it is the year.

The differences are usually small changes.
It could be as small as a bolt change to change the model#
The manual, get a factory one if at all possible. E-bay.
Make sure it's a service manual and not a parts manual.
Aftermarket manuals cover a lot but aren't specific enough.

They sell parts here at this site.
http://www.marineengine.com/parts/force-outboard-parts/50-hp-1990

Jerry,

Thanks very much. I have a Clymer manual on the way and will keep my eyes open for a factory manual.