winterisland
New member
I have a 2004 Nissan NSD50B, (new Tilt and trim style)the power trim quit lifting, the motor and pump works, I first tried adding fluid as I was bleeding it starting leaking from under the resiviour cover. I ordered the O-Ring, Installed today, as I was filling and bleeding with the ramp disconnected from the motor it seemed to be fine, then all of a sudden it started leaking again. I took the unit off and lloked at the part diagram theres not much on the piston side it did come with a couple more O-Rings, but I can't figure how to get the piston out. After you take off the res cover there is a round alluminum something with holes that the fluid goes through and the outside is round, the inside is like the outside of a 6 point axle socket, the rod goes through the center of this. I s it possible to ad to much fluid where it will cause it to leak, again a brand new O-ring and the cover and base look good no nicks. Any help is appreciated. Thank You