Logo
FULL SITE MENU

Rubber Cap in Carburetor nsf3.5b

S

Shiny-Penny

New member
Hi, I am attempting to clean the carburetor on a Nissan nsf3.5b. The float pin Cas stuck, so while wrestling it out I bumped the rubber cap and knocked it out. Thing is, I have no idea where is goes. The diagrams I can find do not show exactly where it goes, only that it goes up "underneath" from the prospective shown. Can any one beore specific as to which hole this little rubber cap goes into?
Thanks a million.
 
You need to pull all the soft rubber parts before soaking anyway, so it is good that you got it out. It will only fit in one place, so you should have no problem putting it back after you soak and blow out all the passages.
 
Back
Top