Logo
Click for Ford Lehman manuals!
Results 1 to 5 of 5
  1. #1

    Default Piston corrosion

    I have an SP225 Ford Lehman installed in an Island Gypsy 32. The intercooler corroded and salt water leaked into the engine, causing corrosion on one piston. My mechanic recommends taking the engine out of the boat and replacing the piston. This is a huge job. Has anyone had this job done? Can you offer any advice? What would happen if I left the engine with the corroded piston? I usually operate the engine at 1800 RPM, and I put about 100 hours on the engine each year.
    Any advice would be greatly appreciated.

  2. #2
    Join Date
    Apr 2016
    Location
    barnegat NJ
    Posts
    2,707

    Default Re: Piston corrosion

    What do the rings look like, Is that piston seized?

  3. #3

    Default Re: Piston corrosion

    Thanks for replying. The corrosion seems to be at the top of the piston. The engine was running fine before I found the intercooler leak, so it is not seized.

  4. #4

    Default Re: Piston corrosion

    Harry, Without seeing the piston it's a tough call, however pitting can cause hot spots and preignition ending in destruction of engine. you will probably find pitted valves in that cylinder also. unusual only one piston, must have been #6?? My advice, send head out for valve job, raise engine enough to drop oil pan,and remove piston and conn. rod.
    Charlie W.

  5. #5

    Default Re: Piston corrosion

    Charlie,
    Thanks for the advice. It was #6. I have already had the valve changed. My mechanic recommends replacing piston, as you said, for the reason you said. I was just seeking a second opinion. Much appreciated.
    Harry

Similar Threads

  1. Honda BF5 corrosion
    By FrederikV in forum Honda Outboard Forum
    Replies: 1
    Last Post: 11-18-2014, 12:43 AM
  2. Corrosion
    By jasoncalleja in forum Honda Outboard Forum
    Replies: 6
    Last Post: 09-17-2009, 11:06 PM
  3. Corrosion
    By f300k in forum Volvo Penta Gas Archive
    Replies: 5
    Last Post: 05-03-2009, 06:44 PM
  4. Dps corrosion
    By tjm in forum Volvo Penta Gas Archive
    Replies: 4
    Last Post: 10-12-2007, 09:20 AM
  5. What is the Best way to clean this corrosion
    By mokaction in forum Johnson Evinrude Outboard Archive
    Replies: 16
    Last Post: 01-03-2007, 02:11 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •