Tom Foolery
New member
Greetings ALL!
I am attempting to remove my Trim/Tilt Assembly (Motor and Ram) That Large Bolted in Pivot Pin is not budging
(trying to remove from Left to Right while looking a the aft of the motor)
I have a brass hammer and applied copious amounts of penetrating lubricant to try to gat it to budge.
I MAY have to go purchase a pneumatic hammer if THAT is what it takes.
May I please ask for your suggestions/comments on this.
Thank you.
Tom
I am attempting to remove my Trim/Tilt Assembly (Motor and Ram) That Large Bolted in Pivot Pin is not budging
(trying to remove from Left to Right while looking a the aft of the motor)
I have a brass hammer and applied copious amounts of penetrating lubricant to try to gat it to budge.
I MAY have to go purchase a pneumatic hammer if THAT is what it takes.
May I please ask for your suggestions/comments on this.
Thank you.
Tom
Last edited: