I have upgraded my outboard engine from a 20 HP Mariner to a 2004 Mercury 25 HP long shaft. I did not have a battery on my old motor but did have controls for throttle and forward and reverse. I used to just pull start it. My new motor seems like it needs a battery or key to start it. It has a 8 pin plug in but only uses 6 of the pins. It does have a pull cord. I am wondering if anyone knows how I can continue to use my remote control cables for throttle and forward and reverse but put in a switch to be able to turn my motor off and on. I would continue to pull start it and not need a battery. Is this possible? I would appreciate any feed back a all.