Logo

DT-5 Ignition issue

blueboat51

New member
I Have a DT5 (white cowl, red/orange decals Blu leg) wih no spark


Main coil under fyweel 150 ohm
triger coil under flywheel 25 ohm

Main HT coils is sealed


Any suggestions wht to replace
Both nder flywheel coils generate AC

thanks in advance
 
I've seen a set of inline HT leads with sliding pins for 6 Cyl 12v systems, but wouldn't plugs earthed outside the head be a good start?

The CDI module is expensive so I want to rule out coils before I get one.
 
An open air gap spark tester can be built with a piece of 1x4 or 1x6 a few finishing nails bent at right angles,alligator clips,solder and wires ala Joe reeves style, Maybe he will respond with the specifics all spelled out. Is battery fully charged? Engine must turn over between 200-300 rpm for stator to produce ignition spark, Hope this helps
 
Last edited:
Hi blueboat51 !
I have a DT5 (0501 327070) andI don't know anything about it.
Can you give me information about the production time?
I have no user's manual. Do you have a pdf. version of it ?
Many thank's for your help in advance,
Brgds
hoatka
 
Back
Top