Logo
Click for Perkins manuals!
Results 1 to 3 of 3
  1. #1

    Default Diesel pre heater help

    Hello everyone i have a Perkins 6354 six cylinder in my brother fishing boat and is a pig to start from cold. We noticed that the pre heater is not connected to the engine at all but is wired in and a switch in the cab. It has the heater plug itself and 2 other wires with a big o end and small.

    Where do the 3 parts connect to ? any help will be great i took pictures as best i can.


  2. #2
    Join Date
    May 2015
    Location
    Oregon
    Posts
    70

    Default Re: Diesel pre heater help

    The pre-heater goes in the air intake, somewhere close to the intake valve. Usually one pre-heater per cylinder. There should be a pipe plug in the intake manifold. If pre-heaters are left on too long they will burn out. Most engines have them controlled by a timer that limits the on time to about 10-15 seconds.
    Diesels start by compressing the air, causing the temperature to rise above the ignition point of diesel. As the engine ages, the rings and valves can allow enough air to escape to prevent starting in cold weather. Your pre-heater heats the incoming air. In really cold weather you may need the cycle them on 2-3 times before trying to start. A block heater works best.
    The big O terminal is probably a ground. It would go on 1st when installing the pre-heater. Usually the block is the ground. The terminal near the top is power. If you don't have a manual, get one. Check the wiring diagram.
    Last edited by Lepke; 02-13-2017 at 05:48 AM.

  3. #3

    Default Re: Diesel pre heater help

    Phayer, as lepke said the large wire terminal goes on first--the glow plug holds it in place. These old engines in some cases were insulated ground so each electrical sender etc. Required a ground connection. The other small terminal is for something else. Suggest following it back to see were it goes. There was only one glow plug mounted in the intake manifold. The small threads on the glow plug connected to the secondary fuel filter with a steel fuel line. As lepke says ,make sure the glow plug works first!
    Charlie w.

Similar Threads

  1. PTC Heater
    By snookwhaler in forum Nissan Tohatsu Outboard Forum
    Replies: 4
    Last Post: 11-17-2016, 08:35 AM
  2. I have sighted a Detroit Diesel 451 Marine Diesel engine in Mobile AL
    By Daniel F. Blanchard in forum Detroit Diesel
    Replies: 9
    Last Post: 07-27-2016, 06:09 PM
  3. ptc heater
    By mistercinder in forum Mercury Mariner Outboard Forum
    Replies: 0
    Last Post: 04-05-2011, 10:58 AM
  4. Heater set up
    By fogun in forum Volvo Penta Diesel
    Replies: 0
    Last Post: 11-11-2009, 03:25 PM
  5. 4 stroke diesel engine vers a 2stroke diesel
    By john motta in forum Other Diesels Mfgs and General Diesel Questions
    Replies: 1
    Last Post: 03-20-2008, 01:16 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •