Iv removed an old powerhead before but since i was replacing the head on that one i was pretty ruff when taking it off.
I have another one for another boat and it looks like its very good nick compared to the other one i attacked.So I am taking this one off to get to the swivel arm.And ill be putting the powerhead back on so i want to be as careful as i can.
Any suggestions? i have all nuts loose.
Whats this pb blaster people talk about on here? is it an american thing? Can i get it in Australia? what about something to freeze the bolts? or what about heating the bolts.Id say its just the four long ones that are the problem.
If heating do i heat just the bolt or the housing aswell where the bolts goes through?Or heat the housing and freeze the bolt?
I have another one for another boat and it looks like its very good nick compared to the other one i attacked.So I am taking this one off to get to the swivel arm.And ill be putting the powerhead back on so i want to be as careful as i can.
Any suggestions? i have all nuts loose.
Whats this pb blaster people talk about on here? is it an american thing? Can i get it in Australia? what about something to freeze the bolts? or what about heating the bolts.Id say its just the four long ones that are the problem.
If heating do i heat just the bolt or the housing aswell where the bolts goes through?Or heat the housing and freeze the bolt?