Thinking I drained all the water out of the system it appears not so, draine the block , and took off some hoses, did not drain the
exhaust manifolds,thinking gravity would do the rest.
After sitting for a year and thru winter , went to start up and was hard startingag poured some gas down the carb and went
for a few seconds.
Did this a few times till I noticed water under the manifolds going into bilge , took off the port side and discovered the crack,
would this cause the stalling?
Heard about welding but think its not worth it , just get replacements. Cracks are on engine side by serial #.
see pics attached
Searay 91
Sorry have to figure outhow to post pics.
exhaust manifolds,thinking gravity would do the rest.
After sitting for a year and thru winter , went to start up and was hard startingag poured some gas down the carb and went
for a few seconds.
Did this a few times till I noticed water under the manifolds going into bilge , took off the port side and discovered the crack,
would this cause the stalling?
Heard about welding but think its not worth it , just get replacements. Cracks are on engine side by serial #.
see pics attached
Searay 91
Sorry have to figure outhow to post pics.