Scotty9615
New member
Good Afternoon
I had an Engine Rebuilder assemble my 318 reverse rotation short block
Oil pumps out of the rear main seal just by cranking the engine over
Two points - A standard rotation Seal was used (based on the recommendation of a Parts supplier)
This engine block has been Align-Bored. I don't believe that the Rear Main Cap or Block were machined
Any thoughts will be appreciated
I had an Engine Rebuilder assemble my 318 reverse rotation short block
Oil pumps out of the rear main seal just by cranking the engine over
Two points - A standard rotation Seal was used (based on the recommendation of a Parts supplier)
This engine block has been Align-Bored. I don't believe that the Rear Main Cap or Block were machined
Any thoughts will be appreciated