Logo
Results 1 to 2 of 2
  1. #1

    Default Chris Craft 283 overheating problem

    Hi. I am new to this forum and hope to get some help on an overheating problem on my 27 foot Aluminm 1963 Chris Craft Roamer with twin 283 engines. The boat ran well when I took it out of the water last fall. I winterized it as usual and was satisfied that the motors had adequate antifreeze. This year when I started it up. The Port engine started fine and water came out the back in about 30 seconds as I am used to. The starboard took about 2 minutes and started pumping but it was erratic and half way to the marina stopped pumping. I have rebuilt the water pump, but still have the same problem.
    My question is Has anyone else had this problem? Thanks in advance for your help. Tom

  2. #2
    Join Date
    Jun 2008
    Location
    Island Heights, NJ,
    Posts
    2,605

    Default Re: Chris Craft 283 overheating problem

    What was the condition of the impeller when you removed it? If not intact, you need to find the pieces.
    Also... do you have strainers on the raw water inlets? IFSO, check for vacuum leaks. If hoses are old, ( or even if recently replaced!) check for a collapsed or kinked hose. Hoses on the inlet side of a raw water pump are supposed to be wire reinforced.
    Capt Bob
    1969 23ft ChrisCraft Lancer
    Merc 5.7L 260HP/ Volvo 280
    1972 22ft Bristol
    Honda 7.5HP 4 stroke Long shaft

Similar Threads

  1. Chris Craft
    By Seeburg4 in forum Other Outboard Motors
    Replies: 1
    Last Post: 08-12-2013, 08:24 PM
  2. Chris Craft Amerosport 284
    By Timothy Scott in forum Chris Craft Engine Forum
    Replies: 1
    Last Post: 07-26-2012, 09:47 PM
  3. Chris Craft 283 swap to GM 350
    By Josh Young in forum Chris Craft Engine Forum
    Replies: 0
    Last Post: 03-13-2012, 06:37 PM
  4. Possible changes to the Chris Craft
    By Rob B in forum Chris Craft Engine Forum
    Replies: 8
    Last Post: 09-03-2006, 10:19 PM
  5. 1962 CHRIS CRAFT OVERHEATING
    By Mike H in forum Chris Craft Engine Forum
    Replies: 1
    Last Post: 09-09-2003, 02:37 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •