Logo
FULL SITE MENU

90 hp force tilt trim

W

wismo

Regular Contributor
I have a 90 horsepower Mercury Force the tilt trim has multiple leaks strip bolts and just isn't working can I eliminate it and still run.

I will use a long bolt of something to keep boat in trimmed position.

I'm getting a cheap winch and bolting it to the floor and I'm making plate to attach to motor to help lift it at the ramp.
 
Last edited:
Depending on the year you can undo the ram on later models or remove the hyd. lines on the older stuff.
It's not gonna lift easy.
You can get the old brackets that didn't have the t@t
 
Is it possible to remove the small Center ram without removing the motor


Realistically if I could locate this centerpiece the part you see andthe front part I could probably get another pump and be good again.
 
Last edited:
Have some leftovers from when I swapped in a tilt trim on my 90Hp. Let me know if you're interested.
 

Attachments

  • OBManualLatch.jpg
    OBManualLatch.jpg
    50.4 KB · Views: 46
This system confuses me
2 lines to tilt pistons and 2 to trim
could I just cap off where the 2 lines are connected to the pump.
 
I think 2 are pressure and 2 are return lines.

If you do unhook and plug the lines and holes.

USE SAFETY GLASSES AND GLOVES WHEN FIRST OPERATING OR TESTING!!!!!
The pressure build up can rip skin and inject oil into your body.
 
Back
Top