John Looker
New member
Hello all, does any one know the size of round stock to use for the block to intake manifold alignment pins? Are they needed? Thanks, John
MarineEngine.com does not offer troubleshooting assistance or repair advice by email or by telephone.
You are invited to join our public Boat Repair Forum to seek assistance from other members.
You may also visit the Boat Motor Manuals section of our site to obtain a service manual.
I would want them in place if I'm using an OEM intake
but there not necessary. Aftermarket companies like
Edelbrock want them removed. They not only help
line up the intake but also hold the gasket in place
however some aftermarket intakes only want RTV used
anyway
Jack