Logo
FULL SITE MENU

BF90 key switch assembly connectors

7

73Outrage

New member
Trying to replace some teak on my 73 Whaler. I need to remove the Honda key switch and tach. For the key switch assembly it looks like I need to separate 3 plastic wiring connectors and 4 bullet connectors. Any tips on separating the plastic wiring connectors? I've tried but no luck. Can't tell if there's a tab to push in, out, etc. And do the bullet connectors just pull apart?

Thx.
 
Bullet connectors do pull apart as one is male and the other female, sometimes the plastic sleeve requires a little persuasion to separate. two small pliers attached to each end where the wire is connected to the connector and gently pulled will do the trick..
Eric
 
There should be a tab on the other connectors that you can get your fingernail under and pull out slightly while you pull the connectors apart.

Mike
 
Back
Top