Logo

under magneto plate wiring?

OntarioGuy

Contributing Member
I am replacing spark plug wires on an 1963 40hp and took it apart a while ago and I can't figure out how to install the throttle butterfly and wire separator(orangaizer holder thing) to the plate itself underneath. I can't seem to find a picture underneath, with the bolt/screw heads would be nice. The schematics are from the side so its hard to tell how it goes together.

Edit: Also 2 wires coming up from the bottom (one red, one black) I'm guessing is ignition/kill switch? do these just go on to each of the points?

Thanks
 
Back
Top