Logo
Results 1 to 2 of 2
  1. #1

    Default mercrusier and nema 2000

    I currently have a 2007 Mercrusier 8.1 with analog gauges. I just installed a Garmin 7612 xsv and would like to get the gauges working via the nema 2000. I have a mercury gateway that a a 10 pin rectangular plug. I plugged the cable into the matching connector on the motor. My garmin is recognizing the gateway but no gauges show on the display. Any suggestions? Do I need a different cable?

  2. #2
    Join Date
    Jun 2008
    Location
    Island Heights, NJ,
    Posts
    2,569

    Default Re: mercrusier and nema 2000

    If your garmin "sees" the gateway, doubt if it is a cable problem...assuming that the gateway you bought works with the engine you have... If it does, carefully read instructions w/gateway to see what if anysetup you need to do.
    Capt Bob
    1969 23ft ChrisCraft Lancer
    Merc 5.7L 260HP/ Volvo 280
    1972 22ft Bristol
    Honda 7.5HP 4 stroke Long shaft

Similar Threads

  1. nema 2000 interface cable
    By magv10 in forum Volvo Penta Gas Engine Forum
    Replies: 1
    Last Post: 07-29-2011, 10:32 AM
  2. NEMA 2000 fuel level sensor
    By ancopre in forum Crusader Marine Engine Forum
    Replies: 6
    Last Post: 10-30-2010, 08:06 PM
  3. Drain plugs for a Merc 50 L 2000 Mercrusier and winterization
    By dirty_dawg in forum Mercruiser Sterndrive Archive
    Replies: 3
    Last Post: 09-15-2008, 11:30 PM
  4. Engine surging between 2000 3200 rpm 50 220hp mercrusier
    By floorplay in forum Mercruiser Sterndrive Archive
    Replies: 2
    Last Post: 07-29-2008, 09:53 AM
  5. Hooking up nema
    By muzz in forum Suzuki Outboard Archive
    Replies: 3
    Last Post: 01-20-2008, 05:17 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •