cosmicsled
New member
Pulled flywheel, replaced the charging coil,or the primary coil, very confusing with several part numbers shown for the coils which look identical, 32130-93E00 or32130-E30 or 32120E20 or 3i20-E10... anyway I got a replacement and installed it, the flywheel will not seat, appears to hit new coil, so after many attempts, with and without keyway I reinstalled the old shot coil, flywheel would not seat, put color on flywheel and it transfered to coil face, whats up? I have changed several flywheels on small motors, I know the magnet can throw you off but NO WAY will it go down on tapered shaft, even with key out. Any ideas? and how do I sort out which coil number to use? thanks, know it sounds basically stupid, I have two identical motors, both flywheels wont go over coil, was not hard to remove, no rub marks on flywheel or coil. Richard