Logo

1978 Mercury Control bx.

Have a look at these,if unreadable,PM me your email address and I'll send you a scanned copy
 

Attachments

  • Photo0190.jpg
    Photo0190.jpg
    45.7 KB · Views: 205
  • Photo0189.jpg
    Photo0189.jpg
    57.9 KB · Views: 168
I reread your post.To remove the unit from the panel,there are two nuts, 3/8" I think, behind the panel that need to be removed and the controls should fall out,well maybe not:D.
If all you want to do is work on the trim switch,there are two small phillips screws hold it in to the handle
 
Remove the wire clip that holds cover on around the warm up button in center of handle then remove the 3 phillips screws and remove handle. The wiring goes thru the 3 screws.
 
Back
Top