Sandyman1216
New member
Hello, new to any forum. Would appreciate any advice. What I have is a 35 that runs good on flush kit but once I launch it won't go quits before I can get it in gear. What I''ve done is replaced head gasket thermostat , water plate gasket.These repairs brought compression from 50lbs to130 both cyl. Did carb rebuild , timing.plugs . Starts and runs great on hose and in tank. Some clues: When I put it back on trailer after 4 failures I noticed grey fuel smelling stuff oozing out of small weep hole above cavitation plate. Get it back on hose and after a few tries it starts up and runs great again . Another thing is the plugs are staying clean an dry. That's it any thoughts .frustrated in south Puget sound Thanks!
Last edited: