Logo

nicks in drive shaft

leelanier

New member
I had a mechanic service my motor and change out the impeller. He couldn't get the plastic and stainless collars that holds down the impellar on the shaft off. So I saw him hitting it with a screwdriver and hammer. He put these nicks in the shaft under where the plastic and stainless rings sit.. Is this something I should worry about? Or would maybe just smoothing it out be ok? Or is that something to worry about to were I should make the guy replace the shaft?? could the impact of him hitting the shaft had messed it up to were it could cause a wobble in the motor or mess up any seals?
 

Attachments

  • 10736115_914692101892985_1176464106_n.jpg
    10736115_914692101892985_1176464106_n.jpg
    23.5 KB · Views: 30
Back
Top