seahorsedad
New member
Greetings All;
I have a '58 5.5 hp Seahorse project. Change out of the impeller, head gasket, powerhead gasket, etc. Your parts diagram for the impeller grommet says "2 Required". I can't seem to figure out why or where the other one would be located. Should only be the one for the water pump housing to the water tube. But then again this is my first project. Any help appreciated.
Thanks,
Donald
I have a '58 5.5 hp Seahorse project. Change out of the impeller, head gasket, powerhead gasket, etc. Your parts diagram for the impeller grommet says "2 Required". I can't seem to figure out why or where the other one would be located. Should only be the one for the water pump housing to the water tube. But then again this is my first project. Any help appreciated.
Thanks,
Donald