Logo

inlet needle ouestion confusion

maximoo

New member
hello all I got this carb kit from discount marine its for a 3hp sears ,the original inlet needle had a rubber tip the new one is all metal and comes with seal .the question is do i install the seal and use the new needle will or do i need to get a new rubber tipped needle my instruction sheet is a little vague on that thanks
 
Tecumseh tried no less than three different needle and seat combinations for the AV 600 series engines, your situation is not uncommon, my best advice is to uprade the carb to a emissions jet type carb with a similar bore size, short of that I need to have it in my hand to modify them to work well .. good luck
 
Back
Top