Logo
Results 1 to 2 of 2
  1. #1

    Default inlet needle ouestion confusion

    hello all I got this carb kit from discount marine its for a 3hp sears ,the original inlet needle had a rubber tip the new one is all metal and comes with seal .the question is do i install the seal and use the new needle will or do i need to get a new rubber tipped needle my instruction sheet is a little vague on that thanks

  2. #2
    Join Date
    Aug 2010
    Location
    Bank of the Ohio river
    Posts
    138

    Default Re: inlet needle ouestion confusion

    Tecumseh tried no less than three different needle and seat combinations for the AV 600 series engines, your situation is not uncommon, my best advice is to uprade the carb to a emissions jet type carb with a similar bore size, short of that I need to have it in my hand to modify them to work well .. good luck

Similar Threads

  1. 1980 Merc 9.8 Inlet Needle & Diaphragm Questions
    By gwfiii in forum Mercury Mariner Outboard Forum
    Replies: 1
    Last Post: 05-01-2014, 09:51 AM
  2. NS3.5A Carburetor inlet needle
    By whitegreg56 in forum Nissan Tohatsu Outboard Forum
    Replies: 1
    Last Post: 12-24-2013, 09:17 AM
  3. Thermostat Confusion
    By major_tom in forum Crusader Marine Archive
    Replies: 9
    Last Post: 10-16-2008, 09:54 PM
  4. Volvo 572 SP Prop Confusion
    By 92wetvette in forum Volvo Penta Gas Archive
    Replies: 3
    Last Post: 09-08-2008, 04:14 PM
  5. Engine confusion
    By mrtmaag in forum Mercruiser Sterndrive Archive
    Replies: 32
    Last Post: 02-06-2007, 03:35 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •