Logo
Results 1 to 1 of 1

Thread: Hurth zf25

  1. #1

    Default Hurth zf25

    Just got a backup Hurth z25M for the installed HBW250 in my boat. I want to do a quick inspection of the used unit when it arrives to confirm that it works as stated. My thought is to split the case, measure the thrust washings (anyone know the acceptable thickness of each thrust washer?) and give a quick look over of the rest of the internals.
    What else could I measure or test without pulling apart all of the gearing? Anyway to determine if the bearings are in good order?

    thx
    Last edited by Malaya; 08-05-2014 at 12:50 PM.

Similar Threads

  1. ZF Hurth tranny noise need help.
    By Floatation Device in forum Marine Transmissions and Reverse Gears
    Replies: 0
    Last Post: 11-10-2010, 12:57 PM
  2. Hurth V Drive
    By kevin_z in forum Crusader Marine Engine Forum
    Replies: 27
    Last Post: 04-29-2010, 09:53 AM
  3. Cheaking oil on hurth transmission
    By lugnutdan in forum Crusader Marine Archive
    Replies: 4
    Last Post: 06-10-2009, 11:29 PM
  4. Cheaking oil on hurth transmission
    By lugnutdan in forum Crusader Marine Archive
    Replies: 0
    Last Post: 06-10-2009, 09:26 PM
  5. Hurth V Drive
    By DavidJensen in forum Archive 2003-2007
    Replies: 0
    Last Post: 08-24-2002, 02:49 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •