Dauntless14
New member
Hi there.
The ilt/Trim on my outboard started spewing oil, it was all rusted. SO I got a new unit. It is a drop in replacement with a motor and a piston all in one. Could someone guide me as to
1- How to remove the old unit. (Is it bolted in or are there any pins to be punched out. DO I have to raise it first.
2- How to fill the oil into the new unit, and how to install it.
I am just looking for simple basics. I have no idea if the oil should be put in with the cylinder retracted etc.
Thank you very much
Here is a picture of the unit:
The ilt/Trim on my outboard started spewing oil, it was all rusted. SO I got a new unit. It is a drop in replacement with a motor and a piston all in one. Could someone guide me as to
1- How to remove the old unit. (Is it bolted in or are there any pins to be punched out. DO I have to raise it first.
2- How to fill the oil into the new unit, and how to install it.
I am just looking for simple basics. I have no idea if the oil should be put in with the cylinder retracted etc.
Thank you very much
Here is a picture of the unit: