[email protected]
New member
Hello again
Ok back story i was having a problem with a clunking noise under a load. ( clutch dogs or shift adjustment). I adjusted the bolt under the bottom carb up so the shift rod would fully engage and the clunking noise has stoped. I also installed a new throttle cable. Now I have a dead spot in my remote controls. Fw will engage as it should. But not until the control is 1/2 way will it actually move the boat. And reverse will not engage unless I remove the shift lever and reinstall it pushed fw to give more room to get into reverse and then it wide open in rev. I have a manual and it says to have 3/16 of the threds protruding from the the remote end of the cable witch I have done. It does not have an adjustment listed from the motor end but I have tried screwing the cable thred in and out but the throttle tower does not move until the control is at 1/2 past forward. What is my next move or should I stop sinking money into a lost cause. Thanks in advance.
Ok back story i was having a problem with a clunking noise under a load. ( clutch dogs or shift adjustment). I adjusted the bolt under the bottom carb up so the shift rod would fully engage and the clunking noise has stoped. I also installed a new throttle cable. Now I have a dead spot in my remote controls. Fw will engage as it should. But not until the control is 1/2 way will it actually move the boat. And reverse will not engage unless I remove the shift lever and reinstall it pushed fw to give more room to get into reverse and then it wide open in rev. I have a manual and it says to have 3/16 of the threds protruding from the the remote end of the cable witch I have done. It does not have an adjustment listed from the motor end but I have tried screwing the cable thred in and out but the throttle tower does not move until the control is at 1/2 past forward. What is my next move or should I stop sinking money into a lost cause. Thanks in advance.