Irishfireguy
New member
Hello everyone,
I have searched for a while and cant seem to find a thread on my probelm (pretty funny for an OMC Stringer). My tilt works fine (up/down) but when I put the drive in reverse it just kicks up away from the boat. when raised out of the water it stays up and I can't push it down manually. I have replaced the tilt motor and repacked the clutch (not disassembled the clutch plates). Does anyone know if there is a way to adjust the tension on the clutch plates (if that is my problem)?
I have searched for a while and cant seem to find a thread on my probelm (pretty funny for an OMC Stringer). My tilt works fine (up/down) but when I put the drive in reverse it just kicks up away from the boat. when raised out of the water it stays up and I can't push it down manually. I have replaced the tilt motor and repacked the clutch (not disassembled the clutch plates). Does anyone know if there is a way to adjust the tension on the clutch plates (if that is my problem)?