Hi there
i don't know if you guys can shed any light on this, stripped down a tad1032ge as it had leaking injector sleeves, taking heads on the seals underneath were stuck to the heads, now I'm assuming that the sealing ring and brass fittings push into the block and the head gasket sits around them so create the seal?
cheers
jonathan
i don't know if you guys can shed any light on this, stripped down a tad1032ge as it had leaking injector sleeves, taking heads on the seals underneath were stuck to the heads, now I'm assuming that the sealing ring and brass fittings push into the block and the head gasket sits around them so create the seal?
cheers
jonathan