Alaskanfisher
Member
Mike,
I found the 3 pin connector you mentioned with the correct colors, but could not get a reading off them. Nothing when I turned the key on and nothing when I crossed the red plug. If there are any codes, are they stored on the ECM? If so, couldn't I just hook that ECM to the other motor, the one with the pgm light and check it that way?
If there are no codes, any suggestions on what to check next?
thank you
I found the 3 pin connector you mentioned with the correct colors, but could not get a reading off them. Nothing when I turned the key on and nothing when I crossed the red plug. If there are any codes, are they stored on the ECM? If so, couldn't I just hook that ECM to the other motor, the one with the pgm light and check it that way?
If there are no codes, any suggestions on what to check next?
thank you