garfield28
New member
G'day all,
New member here so firstly I'd like to say hi.
I have a Johnson 3.3 hp outboard that the pull rope snapped off, so I pulled it apart so I could replace the rope and now I'm stumped as to how the return spring sits in the top of the assembly.
I have taken some snaps of the pieces in the hope someone on this forum has a knowledge of these outboards and how the spring sits in there. I can put all the pieces together but just can't remember how the spring was sitting in that white piece as I pulled it out.
I've searched the internet the last few days looking with no luck whatsoever.
Appreciate any advice
Thanks
Geoff
New member here so firstly I'd like to say hi.
I have a Johnson 3.3 hp outboard that the pull rope snapped off, so I pulled it apart so I could replace the rope and now I'm stumped as to how the return spring sits in the top of the assembly.
I have taken some snaps of the pieces in the hope someone on this forum has a knowledge of these outboards and how the spring sits in there. I can put all the pieces together but just can't remember how the spring was sitting in that white piece as I pulled it out.
I've searched the internet the last few days looking with no luck whatsoever.
Appreciate any advice
Thanks
Geoff
Last edited: