My tilt/trim just clicks when I use the switch. Worked fine last week. The solenoids have been checked and pass. The engine is in the down position and won't go up. I've read several forums and my manual which suggests it might be air and that there might be a manual relief screw on the starboard side to get the engine up manually. I don't see any such "screw". The plastic screw in the port side (fill or check?) has been safely removed with just a little air pressure bleeding off before the screw comes out. I can't get to the pump/motor until the engine comes up... any ideas?
Thanks in advance..
John
Thanks in advance..
John