Tommysmicroskiff
Member
So I picked up a long shaft 15 hp 2 stroke ...
Drove out the roll pin removed the 4 nuts came off EZ Peezy that lower came off
Have a short lower... the nuts have been off but the lu is stuck to the midsection just sprayed the junction point with penetrating oil ... tapped around with a mallet .. still stuck !
heat ?
any known tricks
Drove out the roll pin removed the 4 nuts came off EZ Peezy that lower came off
Have a short lower... the nuts have been off but the lu is stuck to the midsection just sprayed the junction point with penetrating oil ... tapped around with a mallet .. still stuck !
heat ?
any known tricks