Donald Boyer
Member
Hi all, I have a set of Gibson Trim tabs. The ones with the levers to control the hydraulic actuators.
Couple of things are happening/not happening. When I push the levers forward to lower the tabs, one doesn't lower as far as the other.
When I pull the levers back, they do not retract properly unless by water pressure or me pulling them up.
Also I sometimes get fluid leaking out of the reservoir.
So I am thinking that I need to re-bleed both lines. But I'd like some tips/instructions before I go ahead.
Can anyone help please?
Couple of things are happening/not happening. When I push the levers forward to lower the tabs, one doesn't lower as far as the other.
When I pull the levers back, they do not retract properly unless by water pressure or me pulling them up.
Also I sometimes get fluid leaking out of the reservoir.
So I am thinking that I need to re-bleed both lines. But I'd like some tips/instructions before I go ahead.
Can anyone help please?