Hi,
I have a diagnostics problem with a KAD44 EDC
KAD44 EDC - Diagnostic light flashing.
I am getting faults 2.6 (Open or short circuit in supply to Potentiometer in control) and 3.4 (no position signal from gear shift control actuator or outside range)
I have replaced the potentiometer but no joy so i´m hoping it´s in the wiring but I am getting the 5 volts required up the loom to the potentiometer?
As for the shift actuator I think it will need replacing as the plastic cog inside has stripped its teeth!
Any comments appreciated!
I have a diagnostics problem with a KAD44 EDC
KAD44 EDC - Diagnostic light flashing.
I am getting faults 2.6 (Open or short circuit in supply to Potentiometer in control) and 3.4 (no position signal from gear shift control actuator or outside range)
I have replaced the potentiometer but no joy so i´m hoping it´s in the wiring but I am getting the 5 volts required up the loom to the potentiometer?
As for the shift actuator I think it will need replacing as the plastic cog inside has stripped its teeth!
Any comments appreciated!