Logo

Converting riptide auto to i-pilot, W/photo

C-Phase

New member
Picked up a used Riptide ST 24 volt 80lb.
I want to add the new i-pilot GPS tracking system and it seems like a striaght FWD swap. I do have one question however.

There is a single wire coming from the module mounted in the side base cover and it was tie wrapped up through the center of the main coiled harness.
The wire is spliced and wrapped in a coiled wire loom as seen in the photo.
It's a small gauge stranded copper wire.
Any idea what this wire is for?


Thank You

MinnKotainsides1.jpg


The wire in question is the bottom yellow wire

MinnKotainsides.jpg
 
Back
Top