Logo

force 9.9 runs no power

buddydog

New member
My 9.9 runs but when I try to increase speed there is no power I check the fuel system and found no problems. I think it is in the ignition system
 
Same problem here. Checked compression - 110-120 both cylinders. Had just installed new impellor. New Plugs installed. Cleaned up and regapped the points. Spark to ground seems good on both. Cleaned carb but not completely. Found 1 airleak in gas line from tank but that didn't fix it. Checked fuel pump - diaphram intact but seems rather stretched. Will try running at high speed with choke out to see if that increases speed. Will try pumping bulb to see if that helps. Gut feeling is this is carb or fuel pump related. Will advise when fixed.
 
Back
Top