Spongerssuck206
New member
Ok so i figured out my problem with the cylinder not fired thanks everyone for the help, but now im having other problems. So I took it out for the first time in a while last week, and it was running fine in idle but when I would run 3/4 throttle for about 2 min it would do about 40 mph and then bog out and act like it was starving a fuel. So I took the carbs off and cleaned them out and found out the floats were set wrong so I put them back to what the books specifications are.
So here is the problem i took it out today after i set the carbs back to there proper set up. and it was lacking the get up i noticed. When i got it out to the open water it was going like half of its normal speed, and had half its tork it was taking alot longer to to start the plane and just didnt have the get up it had a few days before. I messed with the carbs air screws at the dock and took it out again and it still didnt run at the normal speed. so i started looking at the throttle adjustment but its fine i think it going all the way to full throttle but still no power.
any ideas on the problem
So here is the problem i took it out today after i set the carbs back to there proper set up. and it was lacking the get up i noticed. When i got it out to the open water it was going like half of its normal speed, and had half its tork it was taking alot longer to to start the plane and just didnt have the get up it had a few days before. I messed with the carbs air screws at the dock and took it out again and it still didnt run at the normal speed. so i started looking at the throttle adjustment but its fine i think it going all the way to full throttle but still no power.
any ideas on the problem