Logo
FULL SITE MENU

Corrosion Protection for Terminals in Bilge

S

stan101

Member
Looking for input on best practices to prevent corrosion on terminals located in the bilge. The photo shows a terminal strip protected with a spray product. After only one year in the bilge there is extensive corrosion on the terminals. I need to clean them up and start over with better protection.
IMG_0324 (2).jpg
 

Attachments

  • IMG_0324 (2).jpg
    IMG_0324 (2).jpg
    88.3 KB · Views: 17
I've tried a bunch of stuff over the last umpteen years. So far, the best stuff I've found is CRC Marine 6-56. But you need to re-apply it every 3-4 months or so, which I sometimes forget to do. I use this stuff to spray down the engine (lightly) at every 100 hour maintenance. It also is good on fishing rods and reels.
 
The corrosion control is must when you are using terminals.You have to use good quality products that protects the metals from corrosion.There are many products that protect iron from corrosion but our product is the best because a small quantity of this product can be used to protect any type of metal from corrosion and damage also.
 
Back
Top