Logo
Results 1 to 2 of 2

Thread: Ignition relay

  1. #1

    Default Ignition relay

    I have a 57 Chris craft that is powered by a 1992 marine power 4 cyl. From the ignition/key there is a relay that splits and one leg goes to the fuel pump, one leg to the alternator, and one leg to the ignition coil. I have deciphered that either the relay was bad or something is causing the relay to burn out. So I can bypass this relay to each component individually and it fires up. Then i bought new relays which I can replace the 12$ relay and it fires up but immediately burns out the relay. What could cause the relay to burn out like this. It has been working wonderfully up to this point.

    Thanks adam

  2. #2

    Default Re: Ignition relay

    Can you elaborate on relay burning out? Does engine quit when that happens? How many batteries do you have? Have you unhooked and rehooked any wires? If you haven't changed any wires, I'd guess a faulty coil. Purple wire to alternator and wire to fuel pump shouldn't cause that.

Similar Threads

  1. 1997 Crusader TB454 ignition relay
    By flatsboatmike in forum Crusader Marine Engine Forum
    Replies: 2
    Last Post: 09-09-2009, 06:49 PM
  2. OMC tilttrim relay
    By chip1955 in forum OMC Sterndrive and Inboard Archive
    Replies: 1
    Last Post: 05-04-2009, 09:51 AM
  3. Ignition relay
    By don_mccoskey in forum Crusader Marine Archive
    Replies: 2
    Last Post: 11-06-2008, 07:37 AM
  4. Ignition Relay AQ151C
    By thostorey in forum Volvo Penta Gas Archive
    Replies: 6
    Last Post: 08-23-2007, 12:54 AM
  5. Assist relay
    By jon_allen in forum Volvo Penta Gas Archive
    Replies: 1
    Last Post: 04-09-2007, 11:37 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •