Logo
FULL SITE MENU

Are '98 Evinrudes interchangable with 50 hp and 48 hp. Looking to swap lower ends.

F

fishkiller12672

New member
I have my 50 hp and lower gears are shot. My buddy has the same year but a 48 hp thats supposed to work. Been sitting for years though so i trust my motor. I want to just swap lower ends and save the motor for later parts. Is this ok to do. They are both long shafts as well and both are 1998 two strokes. Thanks for any help.
 
I just found this from another forum. Does it look right.

I have seen quite a number of posts asking for this so here goes:
.....(This chart for direct bolt on with no part changes)............

Horsepower--------------------------------------Years that interchange

40/48/50/55/60..... (small diameter housing)..................1976-1988
40/48/50................................................ .................1989-1992
40/48/50................................................ .................1993-2005
70/75............................(20 inch shaft)......................1978-late 1981
60/65/70/75................................................ .............1982-1988
50/60/70................................................ ..................1989-2001
85-140.............(crossflow 13 spline prop shaft).............1978-1991
88-140.............(crossflow 13 spline prop shaft)..............1992-1998
120-140 Looper V-4... (15 spline prop shaft)...................1985-1991
75-115 60 degree........(bat wing unit 13 spline)...............1995-2006
150-235 & 2.6.................(crossflow V-6)......................1979-1991
185-225.........................(Looper V-6).........................1986-1991
185-225....................(Looper V-6 & Ficht)....................1991-2005
150-250.......................( Magnum Series).....................2002-2007
150-250........................(Lighting Series)......................1997-2001

I will add more as I get information !!!
biggrin.gif
 
Back
Top